NEW! Sealed Bearing Installation Kit (SBIK)
 
This tool can be used for 90% of the hubs on the market- NOW with new square block base to mount in shop vice or clamp to a table.
 

SBIK (Basic Level)
For up to 90% of the hubs on the market- with a new square base.
Can be used on bearings from 24mm O.D. to 35mm O.D. and will accommodate hubs up to 95mm wide. Shaft is 3/8 inch-8 TPI Acme thread. The nut is 11/16 inch hex (or 18mm) with a grade 8 thrust washer. It now is outfitted with a 1 inch square block base which can be clamped in a shop vice, or held in a large adjustable spanner wrench. See complete Product Instructions.